rebuilding my V

[cterrebonne]

Originally Posted by bradford

Love seeing and reading about cap off restorations.

I'd post any questions here so everyone else down the road can benefit from others prior experience.

Very good point bradford.

I did want to share a tip for anyone interested.

The easiest and less messy way I found to remove the foam from the side of the hull is to use a shovel. You basically just dig into the foam and it pops apart in big chunks and there isn't a bunch of dust like you get with a chainsaw or a sander. Each side took me about a 1/2 hour to remove all the foam. I also had those large garbage bags made for putting leaves and grass in. I used them to put the foam inside of and I just put them at the curb after for garbage collection.

Also, what works excellent to remove the remaining pieces of foam is a angle grinder with a wire wheel on it. To get into those hard to reach places a hard bristle wire brush works great.

I also don't plan on putting foam back into the sides. I will cut the edge of the ribs where they meet at the bottom of the hull and the stringers that will allow water to flow back into the bilge.