Stator question

[Striper80]

I was winterizing my engine and noticed a little black goo had dripped a little onto the timing base. It’s my understanding that this is a failing stator. My engine seems to charge ok and my tach isn’t erratic. I do have an issue where I can’t get above 5100 rpms, not sure if it could be related. The engine is a 98 200 Johnson.

[THEFERMANATOR]

Originally Posted by Striper80

I was winterizing my engine and noticed a little black goo had dripped a little onto the timing base. It’s my understanding that this is a failing stator. My engine seems to charge ok and my tach isn’t erratic. I do have an issue where I can’t get above 5100 rpms, not sure if it could be related. The engine is a 98 200 Johnson.

They ALL do it. I had one that was still going 5 years after I had 1st seen it dripping, and it was still going. It only seems to happen to the 35 amp stators, and it's the charging side that leaks out. On the smaller stators they encased them in plastic, and you never had much trouble with them oozing out.

[Striper80]

Originally Posted by THEFERMANATOR

They ALL do it. I had one that was still going 5 years after I had 1st seen it dripping, and it was still going. It only seems to happen to the 35 amp stators, and it's the charging side that leaks out. On the smaller stators they encased them in plastic, and you never had much trouble with them oozing out.

Any chance that it would have something to do with my low rpms? I’m sure that Stiletto prop will help with the speed but I have a feeling the rpms will still stop where they are.

[THEFERMANATOR]

I highly doubt it has anything to do with it. It's the charging system side that drips out, the ignition charge coil, and S.L.O.W. coils are part of the stator, but sealed seperately. And these aren't like Mercs with a low speed and a high speed charge coil, they use just 1 coil to charge the CDI unit, and another coil for the S.L.O.W. system that controls the rev limiter and other safety functions. I had a stator fail on me once, engine ran great all the way up to the 6700 limiter, but it started like crap and would randomnly lose cylinders at idle, but all came right back to life once I gave it some throttle. If you're getting 225 volts during craking, your stator is most likely fine.

[steplift20]

Dam Ferm I want to be your best friend If you ever buy a house in Morris county MJ Let me know Lol Your good bro

[spareparts]

Ferm beat me to it, they all do that. I knew a tech that would replace every stator he saw that was leaking, he made a lot of money till he started charging for ones he just replaced

[Striper80]

Thanks ferm, I kind of figured that. It’s only dripping a little and I have none of the symptoms of a failing one.

[THEFERMANATOR]

All of the 35 amp stators leak after 2-3 years, just how they are. The only thing you do need to watch for is that the black goop doesn't get into the timer base, and cause it to stick. I've seen that happen which will make it run poorly up top because the timing wouldn't fully advance. Otherwise, don't worry about it.

And me and Jersey don't mix. My wife has tried MANY times to get me to move, it aint happenin.

[bradford]

I thought Florida was now part of New Jersey?

[THEFERMANATOR]

Originally Posted by bradford

I thought Florida was now part of New Jersey?

More so Michigan and New York.