Time for a new project...

[Airslot]

Got home from work with a little daylight so I got to work on the tabs. Took pics along the way. I got them mounted entirely as far as the outside goes. First time in my life that I got the 5200 where it was supposed to go. Not wearing any. I have to mount the pump, the switch, run the wiring, make the positve and ground connection, and I'm done. When finished I'll write up an install piece w/ pics.

Airslot

[Airslot]

Here's a little teaser for the picture hounds.



Airslot

[msbhammer]

Looking Good Airslot ;)

[macojoe]

You are teasing!! I want to see them on, know how hard it was, whats the difference in ride!!

And also need a MJ trim tab, donation gig!! ;)

[Zebra]

Whats the dimension of those tabs, they look narrow and long like what you find on a high performance rig. what kinda of controls did you get for the tabs... Z

[Airslot]

Here's for MJ...


They are Bennett M-120's, size is 10" x 12", batwind design.

The install has been easy so far. I have to run the eiring harness and install the switch. I may have 30 minutes free tonight so I hope to accomplish something.

Airslot

[macojoe]

Just ask and you shall receive!!

Looks good so far!! Can't wait for the report on the ride!!

[Airslot]

Hope to give a full report tonight, maybe tommorrow. Sucks that work gets in the way of our hobbies. I buttoned up a few things last night, installed and wired the switch, pulled the wiring harness...

Tonight I have to install two ring terminals and hook up the power and ground and then its off to the bay. Weather looks good but that means I'm busy at work.

Airslot

[C YENSEN]

HEY I CANT WAIT TO SEE HOW YOU SAY THOSE THINGS HELP OUT, SO YOU CAN COME PUT THEM ON MY BOAT. ;D

[Airslot]

Cy, bet we could do the job in two hours now that I've done em.

Airslot