|
|
#1
|
||||
|
||||
Floor Hatch Handle
I have a flat round floor hatch handle on my V20. It is very difficult to get a hold of. **Has anyone changed theirs? *If so what did you switch to? *Thanks! *Bill Mc ;D
This post should of been placed in modifications. After posting it in General is there an easy way to move it? Thanks again
__________________
 Now being pushed with the Force of an E-Tec! http://www.wellcraftv20.com/gallery/...1990-V20-Sport http://www.youtube.com/watch?v=9ESnJm4uxug 
|
|
#2
06-24-2004, 09:00 AM
|
||||
|
||||
|
Re: Floor Hatch Handle
replaced my old teak hatches with 3/4 starboard...drilled and routed finger holes in each end...5 years ago, many openings, no problems
__________________
'74 V-20/ BF 150 '95 V-21/ BF 150 '84 V-20/ 200 2.4 Merc '87 V-20/'18 F150 Yamaha 
|
|
#3
06-24-2004, 01:18 PM
|
|||
|
|||
|
Re: Floor Hatch Handle
If they are the same as my old 1974 , you might try putting a small rubber washer on the bolt . That should give it enough offset to grab the nob .
__________________
1994 V20 Fisherman & 2004 Yamaha 150
|
|
#4
06-24-2004, 10:08 PM
|
||||
|
||||
|
Re: Floor Hatch Handle
I'll give the rubber washer a try. Thanks Bill Mc ;D
__________________
Now being pushed with the Force of an E-Tec! http://www.wellcraftv20.com/gallery/...1990-V20-Sport http://www.youtube.com/watch?v=9ESnJm4uxug
|
 |
|
|
Linear Mode
