Floor Hatch Handle
 

I have a flat round floor hatch handle on my V20. It is very difficult to get a hold of. **Has anyone changed theirs? *If so what did you switch to? *Thanks! *Bill Mc ;D

This post should of been placed in modifications. After posting it in General is there an easy way to move it? Thanks again

Re: Floor Hatch Handle
 

replaced my old teak hatches with 3/4 starboard...drilled and routed finger holes in each end...5 years ago, many openings, no problems

Re: Floor Hatch Handle
 

If they are the same as my old 1974 , you might try putting a small rubber washer on the bolt . That should give it enough offset to grab the nob .

Re: Floor Hatch Handle
 

I'll give the rubber washer a try. Thanks Bill Mc ;D