VRO

[bassarama]

Finally...the day came.

Okayyyy, I hope I didn't screw up here, I cut up a section of the VRO intake hose and stuck a SS 5/16 bolt and clamped it.

Here's the motor:

( don't know what is that bottle doing in my boat!!! ;D)



A bit closer:



Side view:



Oh and I also installed my new Racor filter:



I removed the holding tank and cut the two wires leading to the motor, tomorrow I'll run it with the 50:1 pre-mixed.

Should I remove the whole wire harness, or just jump the end so there's no alarm goning off?

Thanks :)

Joe