|
|
#4
10-05-2022, 07:51 PM
|
||||
|
||||
Where did u unplug the vent hose from, the tank or the fitting on the gunnell?
Should not be any gas in the vent hose, it is higher than the tank. I know some gets in when filling tank, sometimes there is a loop put in to trap water or fuel, but should be able to blow through it with no back pressure Disconnect both ends and make sure it***8217;s not restricted in any way On this tank, the vent and fill are on the forward end of the tank, not the stern end ,right? 
|
|
|
Threaded Mode