Rebuild Repower

[Slightly_Twisted]

The first picture is of the gas tank area. I couldn’t get it to fit right with a pvc pipe running under the tank so I made a false floor to enclose the tanks from the bilge. The area under the tank is more the enough room for water to flow.

The next is the lay out for the bracket, this wasn’t as bad as I thought. I was able to get all the information marked and was happy with the lay out. The curve on the transom has been a problem from the start, and continues to be a pain. I couldn’t use a straight edge like a level I had to use string and the mark every few inches for any mark going across. So the two semi vertical line on the outside are the edge of bracket tub the are angled about 15 degrees out from the center line. The two horizontal lines are the previous water line the lower one, and the higher up one is the top of the bracket 6 inches above the old water line. Then the bottom of the bracket is 3 inches above the bottom of the transom.

I had a 30 Aluminium sign we took Down from the soccer fields at work and thought it would be perfect for the mold. I ended up getting some melamine boards to use for the sides and back.

Will continue later