Pour able transom

[Redloon]

Huron Blue,

Thanks for the information. One question on using the Seacast - How did you check for leaks into the bilge area before pouring the Seacast?

It looks like you used Duct Tape to seal the engine mounting holes on the outer transom skin. Did you use that on the inner skin also?

I'm thinking of using Seacast after cleaning out the rotten transom wood on my project. I was thinking of pouring water into the cavity between the outer skin and the inner skin - that for sure would show any potential holes where the Seacast could flow into the bilge.