voltage regulator burnt
So.. my voltage regulator burnt on my 1984 merc 488. I decided to replace the voltage regulator with a alternator. I bought a kit and have installed it and before I start the motor I want to run it by you guys first.
My motor has a power steering pump on it so I connected the alternator bracket to the block and have a belt running from the stator to the power steering pump and then on to the alternator. There are three wires from the alternator one red, one orange and one black. The red and orange wires connect together and are run to the fuse block on the starter motor. The black wire is connected to the coil. I have disconnected the old voltage regulator ,cut the wires running from the stator and will put marrets with rubber paint to seal the wires running from the stator.
Do you think this set up is correct? I have pictures I can post.
|
Threaded Mode