|
|
|
|
#1
|
|||
|
|||
Replacing fill/vent lines
n
Last edited by barnegatV20; 11-26-2014 at 02:16 AM. 
|
|
#2
06-09-2012, 04:17 PM
|
||||
|
||||
|
When i replaced the fill line in the 250 Sportsman, i unhooked it from the tank then used a piece of 1 1/2" OD pipe to join it to the new one with screws. Then i pulled the old one out from the fill side and it pulled the new one behind it.
__________________
1983 V-20 capsized. . . . in the garage.
|
|
#3
06-09-2012, 10:36 PM
|
||||
|
||||
|
It does run through some foam, but should wiggle free. Your problem sounds familiar, and I hope for the simplest fix for you... but you may need a new tank. I'm in the process of ordering a custom tank now, and it ain't gonna be cheap.
|
|
#4
06-09-2012, 10:44 PM
|
||||
|
||||
|
It takes two people, one to push one to pull. A little cussing might help too.
__________________
1983 V-20 capsized. . . . in the garage.
|
 |
|
|
Hybrid Mode
