Trim and tilt wanted for 1976 135 evinrude

[Kracker Jack]

Originally Posted by gw204f

Some of these might work for you...

http://smd.craigslist.org/boa/2892092504.html
http://smd.craigslist.org/boa/2884012519.html
http://smd.craigslist.org/boa/2861039665.html

gw thanks for the info.yes that one 135 for 200 dollars would be perfect. Kinda of a far drive. But thank you for the help.

[GillV20]

And you think the setup from a V6 88 150 will work? I got pics of it today. I am almost positive the electric motor will need to be replaced. But a side from that I did get a decent look at it today. I also got pictures but it will take me a little while before I can post pics.

[Kracker Jack]

Is that motor a 20" or a 25"?

[GillV20]

25"

[Kracker Jack]

wow she is eat up. Have you hooked it up to a fresh battery to see if it works? The problem is they changed the size off the main pivot shaft. My 76 has a smaller spline and small diameter main pivot shaft than new motors in the 80's. I have a 85' transom bracket that i can put on my 76' but my 76' pivot shaft is 1/6 inch smaller creating slop in the shaft. This part is the only thing im missing to have all parts needed for my build.

[GillV20]

That is why I am not rebuilding it. I figured $150 for the whole thing would be a good deal to who ever needed the lower unit.

[gw204f]

kracker, are you talking about the pivot tube (side to side swivel) or the tilt tube (up and down)? If it's the the tilt tube, maybe you could have a machine shop turn some sleeves to fit over your tilt tube to make it snug in the '85 transom bracket. Heck, that might even work if it's the pivot tube. I don't know enough about how all that stuff fits together...

[Kracker Jack]

Originally Posted by gw204f

kracker, are you talking about the pivot tube (side to side swivel) or the tilt tube (up and down)? If it's the the tilt tube, maybe you could have a machine shop turn some sleeves to fit over your tilt tube to make it snug in the '85 transom bracket. Heck, that might even work if it's the pivot tube. I don't know enough about how all that stuff fits together...

I have already thought about that. And will be my next move. I have that whole mid section transom mount bracket assembly. All I would to do is sleeve the vertical shaft some how. And get a used trim and tilt assembly. I'm not trying to half *** it but how harm can you do if you keep the grease to her.

[Kracker Jack]

Gw204f I called that guy in Maryland and he sold those motors. But he might a bracket assembly for me. Cross your fingers. That's s pretty far trip for me though!

[gw204f]

Are you talking about the guy in Hollywood? If so, I'm not far from there so let me know if there's anything I can do to help out.