|
|
|
|
#1
|
|||
|
|||
I was going to drill a few small holes to see if there is foam in the rest of the floor but after reading some of the posts i think its safe to say that wellcraft only used the foam around the fuel tank........poengine33
|
|
#2
04-22-2009, 08:36 AM
|
||||
|
||||
|
Mine is 84, foam around the tank only. By the way, last time I looked at the entire tank, noticed that the foam was forming a little wall at the aft center top area, where the water drains out from the top of the tank. I removed all the foam from the aft rear top edge, and now water just flows out to the bilge.
__________________
Make the habit of radio-checking your VHF, and use it. Father God is too busy to come down to help you himself, He sends His Angels. They have no wings, They are just your true friends.
|
|
#3
04-22-2009, 08:38 AM
|
||||
|
||||
|
I also remember that I removed the port side chair base, because the floor roted and could not support the seat anymore, and to cover the hole, I cut the floor and installed a 10" rectangular floor hatch, so the bilge there could be used as storage. I found no foam at all in that area.
__________________
Make the habit of radio-checking your VHF, and use it. Father God is too busy to come down to help you himself, He sends His Angels. They have no wings, They are just your true friends.
|
 |
|
|
Hybrid Mode
