oil injection removal ...

[spareparts]

I just remove the drive gear behind the pump and put the pump back in place. remove the tank in the boat, plug the crank case pulse port to the main tank with a pipe plug th same size(follow the oil lines to the engine). remove the warning module and the oil sensor, remove the Tank on the engine, take the oil pump hoses off, remove the fitting where the oil line runs into the fuel line. I'm probably forgetting something, I'll rememebr it later. After you are done, check the over heat circut by gounding out the temp sensor(tan blue wire) with the key on, it should sound the alarm. Make sure to add oil to the fuel tank before running the engine