|
|
#11
03-27-2008, 10:26 PM
|
||||
|
||||
I would try a 15 pitch stainless wheel myself, but somethin don't sound right here. Are you sure your hitting on all cylinders under load? Is the timing set to 18 BTDC @ 5000 RPM's(very important that it is set at 5K as the power pack has about 4 degrees of advance in it with RPM due to trigger and stator outputs). Loopers are CRITICAL of timing. I would get you a bo0ok and go through the carbs top to bottom, make sure the plastic bodies are not warped. Then set the timing and go from there. To bad you aint closer, I'd help you figure it out as I'm fairly proficient with the V4 90 degree loopers.
__________________
2011 SUNDANCE B20CCR SKIFF, 2011 YAMAHA 90HP 4 STROKE, 2011 KARAVAN SINGLE AXLE ALUMINUM TRAILER, LOWRANCE ELITE-7 HDI, MINN KOTA RIPTIDE TROLLING MOTOR 2000CC HYDRA-SPORT 225+HP EVINRUDE SOLD  AND THE PINK JEEP!!!! R.I.P. http://www.wellcraftv20.com/communit...ad.php?t=11664 
|
|
|
Threaded Mode