|
|
|
|
#1
|
|||
|
|||
BGA:
I newer 22' Angler with T-Top in Tampa. Very reasonable price http://tampa.craigslist.org/boa/574817884.html Kamikaze
__________________
 74 V20 CC with a 150 Johnson (Gone but not forgotten) 89 V20 Cutty with a Tower (Build in process) 
|
|
#3
02-15-2008, 04:15 PM
|
||||
|
||||
|
Quote:
If this thing checks out, I think it would be a screaming deal... I've heard some of the guys complain about the Anglers on this board and I welcome any further thoughts folks might have...
__________________
 1990 Hydrasports 2000cc Vector with 96 200HP Oceanrunner. Saved by grace alone, through faith alone, in Christ alone http://www.providencerpchurch.com/ Last edited by Bygracealone; 02-15-2008 at 04:35 PM.
|
|
#4
02-15-2008, 04:44 PM
|
||||
|
||||
|
I've never worked on them, so I don't have any first hand experiance with them, but I do know the dealers ship for them around here was passed around like a bad case of the clap. From what I heard, there are built by all the people that Tracker didn't keep when they bought out Mako, don't know this to be fact, just what I heard
|
|
#5
02-15-2008, 07:19 PM
|
|||
|
|||
|
BGA:
I agree the price is low but don't forget the ad doesn't say anything about a trailer. Kamikaze
__________________
74 V20 CC with a 150 Johnson (Gone but not forgotten) 89 V20 Cutty with a Tower (Build in process) Last edited by kamikaze; 02-15-2008 at 08:21 PM.
|
|
#6
02-15-2008, 08:00 PM
|
||||
|
||||
|
Quote:
__________________
1990 Hydrasports 2000cc Vector with 96 200HP Oceanrunner. Saved by grace alone, through faith alone, in Christ alone http://www.providencerpchurch.com/
|
|
#7
02-15-2008, 08:13 PM
|
|||
|
|||
|
BGA:
I agree, If the engine and hull checks out it's a steal. But I'll still perfer the Dusky (I like closed transoms) However, up where you are in the bay it doesn't get more then 4 feet deep and waves are but no existent - so I'm sure the Angler will be fine!  Kamikaze
__________________
74 V20 CC with a 150 Johnson (Gone but not forgotten) 89 V20 Cutty with a Tower (Build in process)
|
|
#8
02-15-2008, 08:17 PM
|
||||
|
||||
|
I had a 78 19' ANGLER CC once, it wasn't a great boat. But the one I had had been worked over and beat over pretty good before I got it. I know down here in FLORIDA they aint regarded that highly. If you need somebody to check out a boat in TAMPA, it isn't that far for me. I'm only about 20-25 miles from there. As for the KEVLAR hulls, I've only heard 2 bad things about them. Ther whole hull isn't KEVLAR, just the KEEL, lifting strakes, and some of the other main structural points have a layer of KEVLAR in them. They tend to be lighter because of the lesser amount of glass cloth needed for strength, which in turn makes them ride over the waves a bit more. And if you get any hull damage, KEVLAR acts like a sponge and will soak up water. If the hull is cared for though, they are pretty much golden and a favorite down here in FLORIDA.
__________________
2011 SUNDANCE B20CCR SKIFF, 2011 YAMAHA 90HP 4 STROKE, 2011 KARAVAN SINGLE AXLE ALUMINUM TRAILER, LOWRANCE ELITE-7 HDI, MINN KOTA RIPTIDE TROLLING MOTOR 2000CC HYDRA-SPORT 225+HP EVINRUDE SOLD  AND THE PINK JEEP!!!! R.I.P. http://www.wellcraftv20.com/communit...ad.php?t=11664 
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
