|
|
#2
05-02-2006, 05:43 PM
|
||||
|
||||
Re: In hull transducer mounting/placement .
Not here, but I'm listening . . . er, watching.
|
|
#4
05-03-2006, 08:03 AM
|
||||
|
||||
|
Re: In hull transducer mounting/placement .
Are you talking about using a transom mount transducer and using it as a shoot through. Iv'e heard of this working. I think they use silicone, and make sure there are no air bubbles in it underthe ducer. Check out thehultruth.com.
__________________
If your not living on the edge.....your taking up space.
|
|
#5
05-03-2006, 09:37 AM
|
|||
|
|||
|
Re: In hull transducer mounting/placement .
Done it. It's very easy. Just make sure of placement for a good signal and no air bubbles between hull and transduscer. Take the boat out with a friend and have them try different locations as you operate the boat for the best signal. Good luck.
|
|
#6
05-03-2006, 09:39 AM
|
||||
|
||||
|
Re: In hull transducer mounting/placement .
there's an epoxy you use to hold them on the bottom and yes you must have the transducer epoxyed in with no voids or air pockets between the hull and the transducer. I have them in my Sea Ray and they all work great. Your hull must be glass only (No Wood) an all have a certain thickness they will work thru read your box to be sure it will shoot thru the hull you may need to grind the hull to get it thin enough to work. good luck
__________________
 1978 V20 Cuddy w/ 225 Johnson. And Several other boat's
|
|
#7
05-03-2006, 09:43 AM
|
||||
|
||||
|
Re: In hull transducer mounting/placement .
Quote:
|
|
#8
05-03-2006, 10:02 AM
|
||||
|
||||
|
Re: In hull transducer mounting/placement .
I've got an Airmar P-79 ?I think thats the model? that is in the stern of mine. IT's the one with the casing that you silicone down and fill w/ mineral oil. To make a long story short, I'm still using the transom mount 'ducer. I never got as good a reading w/ the shoot through. I may play with it again this year.
Airslot
__________________
Airslot Airslot's V-20 Gallery
|
|
#9
05-03-2006, 01:30 PM
|
|||
|
|||
|
Re: In hull transducer mounting/placement .
I have a lowrance transom mount transducer . My old one kept getting broken by the fork lifts . I want to glue this one in and did not know if there was a spot that had been successful in which to mount it .
__________________
1994 V20 Fisherman & 2004 Yamaha 150
|
|
#10
05-03-2006, 03:23 PM
|
|||
|
|||
|
Re: In hull transducer mounting/placement .
I sent an email to Wellcraft and ask if they could assist with the best location . Tom Dystra returns with :
"6 to 8 inches off the keel and 12 inches forward of the transom " I'm going to give that a shot this weekend .
__________________
1994 V20 Fisherman & 2004 Yamaha 150
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
