Forum: Repairs
08-16-2011, 08:01 PM
|
|
Replies: 13
Views: 700
Emergency stop switch
Question, I lost spark today on all cylinders while at dock, Just replaced ignition coil, had her running, idling smooth, reved her up to 2000 for a sec. sounded great, smoothest ever. Wanted to...
|
|
Forum: Performance
08-16-2011, 04:14 PM
|
|
Replies: 9
Views: 490
Spraying ether to start
How can I spray ether into the carbs without removing the air silencer on a 1994 150 HP Ocean Pro 60 Degree Looper
|
|
Forum: Performance
08-14-2011, 05:06 PM
|
|
Replies: 13
Views: 1,044
|
|
Forum: Repairs
08-14-2011, 05:02 PM
|
|
Replies: 7
Views: 421
|
|
Forum: Repairs
08-12-2011, 02:44 PM
|
|
Replies: 7
Views: 421
|
|
Forum: Repairs
08-09-2011, 02:18 PM
|
|
Replies: 7
Views: 421
Throttle cable adjustment
How do I know if my throttle cable is adjusted correctly ? I had an idiot mechanic, just can't trust anything he did, and I know he fooled with my cables. Thanks for any input:head:
|
|
Forum: Repairs
08-09-2011, 02:14 PM
|
|
Replies: 19
Views: 930
|
|
Forum: Repairs
08-08-2011, 09:53 PM
|
|
Replies: 19
Views: 930
|
|
Forum: Repairs
08-07-2011, 12:44 PM
|
|
Replies: 19
Views: 930
|
|
Forum: Repairs
08-05-2011, 01:42 PM
|
|
Replies: 19
Views: 930
No, I didn't, I am thinking about checking the...
No, I didn't, I am thinking about checking the fuel pump tomorrow, but I would rather not do that yet because I have no trailer and I have to work on this in the water on my mooring ball, I don't...
|
|
Forum: Repairs
08-04-2011, 08:04 PM
|
|
Replies: 19
Views: 930
I would be curious to know the answer to that...
I would be curious to know the answer to that also ! My whole fuel system I installed last year, all new except the tanks, which i cleaned with pebbles and acetone. Water seperator and all lines...
|
|
Forum: Repairs
08-04-2011, 03:41 PM
|
|
Replies: 19
Views: 930
|
|
Forum: Repairs
08-03-2011, 02:02 PM
|
|
Replies: 19
Views: 930
|
|
Forum: Repairs
08-01-2011, 01:51 PM
|
|
Replies: 1
Views: 217
Using seperate uel can with VRO
I'm trying to isolate what I think might be bad gas, I was thinking of using a seperate 6 gal. can that is full of fresh gas at a 75:1 mix ( a friends )to run the engine along with the VRO hooked...
|
|
Forum: Repairs
08-01-2011, 01:36 PM
|
|
Replies: 19
Views: 930
Compression results
Did comp. test this morning with a brand new screw in type tester. Had to do it with the engine cold, I can't start it. I got 120 lbs. on all three starboard side cyl. Had 100 lbs. on all three port...
|
|
Forum: Repairs
07-31-2011, 09:27 AM
|
|
Replies: 14
Views: 802
Did comp. test this morning with a brand new...
Did comp. test this morning with a brand new screw in type tester. Had to do it with the engine cold, I can't start it. I got 120 lbs. on all three starboard side cyl. Had 100 lbs. on all three port...
|
|
Forum: Repairs
07-30-2011, 10:12 PM
|
|
Replies: 14
Views: 802
Well went out today. Got to boat swap out the...
Well went out today. Got to boat swap out the fuel / water seperator filter next off to gas dock ( 16 Gal high test ), had a problem threading on my Perko plastic gas cap, I deformed the threads and...
|
|
Forum: Repairs
07-30-2011, 05:44 AM
|
|
Replies: 14
Views: 802
|
|
Forum: Repairs
07-29-2011, 01:58 PM
|
|
Replies: 14
Views: 802
|
|
Forum: Repairs
07-28-2011, 05:50 PM
|
|
Replies: 14
Views: 802
Sounds good, butterflys open is the same as...
Sounds good, butterflys open is the same as manually holding the throttle full open at the engine corrrect? Jumping the selenoid is the same as cranking the engine with the safety lanyard (kill...
|
|
Forum: Repairs
07-28-2011, 02:43 PM
|
|
Replies: 14
Views: 802
Compression test
Can anyone tell me the proper way to do a compression check on a 1995 150 HP Ocean Pro ? Thanks:head:
|
|
Forum: Performance
07-24-2011, 09:38 PM
|
|
Replies: 24
Views: 1,987
|
|
Forum: Repairs
07-23-2011, 10:16 PM
|
|
Replies: 9
Views: 452
|
|
Forum: Repairs
07-23-2011, 12:11 PM
|
|
Replies: 9
Views: 452
sounds complicated, maybe I'll just leave it. I...
sounds complicated, maybe I'll just leave it. I am getting 4200 RPM's max running a 15-1/2 X 15 Alum. prop recently repitched for more RPM. Yesterday I got 29mph @ 4200, 2 adults 4 small children, 35...
|
|
Forum: Repairs
07-23-2011, 06:46 AM
|
|
Replies: 9
Views: 452
|
