|  | 
| 
			 
			#1  
			
			
			
			
			
		 | ||||
| 
 | ||||
|  Will thread lock work.... 
			
			.....inside the float bowl of my Rochester carb. 3 times now the jet/port whatever ya call it that the needle valve shuts off by the float has loosened up dropped down a bit *and caused the bowl to starve for fuel, causing the motor to only idle. I've tightened it up real good but, I 'spose the vibration is too much. I tho't I'd put some threadlock but, dunno if the gas will dissolve it post haste. Any thoughts? TIA
		 
				__________________ Doug aka "Hammerhead" Jensen Beach, Florida '77 V-20 165 I/O | 
| 
			 
			#2  
			
			
			
			
			
		 | ||||
| 
 | ||||
|  Re: Will thread lock work.... 
			
			I know they make thread locker stuff that is impervious to solvents but don't know if that is how you are supposed to correct that.
		 
				__________________ Willy 1986 V20 Old School 1992 V20 1992 150 Yamaha 1997 HydraSport 2250 Vector 2009 17' G3 Outfitter "G Spot" http://www.youtube.com/watch?v=TDebw...eature=related "I won't be wronged, I won't be insulted and I won't be laid on a hand on. I don't do these things to others and I require the same from them" JW | 
| 
			 
			#3  
			
			
			
			
			
		 | ||||
| 
 | ||||
|  Re: Will thread lock work.... 
			
			well it might work? I hate to see you add something in there and it melt and clog something else!! How about getting a star washer?? They are thin and that just might do it for you? Its only 1/16 inch Just a thought. 
				__________________ 1986 V20  Old Fishermen never die, we just SMELL that way!! | 
| 
			 
			#4  
			
			
			
			
			
		 | ||||
| 
 | ||||
|  Re: Will thread lock work.... 
			
			Hammerhead, the little bit of Lok-Tite you'll use on that screw won't have any ill effects...after 3 times (this'll be the 4th), I'd put LT and a star-washer if it'll fit... ;D...
		 
				__________________ '74 V-20/ BF 150 '95 V-21/ BF 150 '84 V-20/ 200 2.4 Merc '87 V-20/'18 F150 Yamaha | 
| 
			 
			#5  
			
			
			
			
			
		 | ||||
| 
 | ||||
|  Re: Will thread lock work.... 
			
			ThanX guys.....didn't think of a star washer :-[ I'll get one tomorrow. 
		 
				__________________ Doug aka "Hammerhead" Jensen Beach, Florida '77 V-20 165 I/O | 
|  | 
| 
 | 
 |