|
|
#2
09-07-2006, 10:25 PM
|
|||
|
|||
SKOOLS - rebuild advice needed
Skools:
I am thinking about rebuilding my 235 this winter (compression across each cylinder is currently 75 PSI. Compression was 95 PSI at start of the season). I recently replaced the head gaskets and verfiied that none of the cylinder walls are scored, so my question is: Can I just hone each cylinder and replace the rings, Or do I need to bore and replace with over sized pistons. What would you recommend is the BEST way to go??? Thanks Kamikaze
__________________
 74 V20 CC with a 150 Johnson (Gone but not forgotten) 89 V20 Cutty with a Tower (Build in process) 
|
|
|
Threaded Mode