![]() |
|
#1
|
||||
|
||||
|
well, i was fishing with a buddy on thursday (one of my favorite spots and thankfully our peace and quiet wasnt interupted by any of those pesky fish) and i decided to open her up for a second or two. well, she got up and danced but only turned 3600 rpm. guess she was running about 40 or better but the rpms seemed a bit low to me. the motor is a 350 chevy. anybody care to chime in?
__________________
hammer aint. stinkpot aint. sawdust aint. rainbow aint. maco sure as sh!t aint. randle? ha ha ha. |
|
#2
|
|||
|
|||
|
.....should be up around 4200-4500....so I've read
|
|
#3
|
||||
|
||||
|
tell you the truth... if she runs in the 40's at 3600, i dont think i wanna run her at 4200 - 4500.
to dam fast for me.
__________________
hammer aint. stinkpot aint. sawdust aint. rainbow aint. maco sure as sh!t aint. randle? ha ha ha. |
|
#4
|
||||
|
||||
|
But, if your motor doesn't max out at 4200-4600 WOT, you are overworking the motor and will cause problems down the road. It's not a good situation to have "enough speed for me" at less than the recommended WOT RPM's.
Find out the cause.
__________________
Heavily medicated for your protection. |
|
#5
|
|||
|
|||
|
Charlie, Hmm, I think that boat is just way to fast for. Time to s ;D ;Dell her for half the price. ;D ;)
__________________
|
|
#6
|
|||
|
|||
|
Phesters right, a 350 should run at 4200rpm if propped correctly. 3600 seems real low. Mine runs at 4200 and its over 25 years old.
|
|
#7
|
||||
|
||||
|
ok, so where do i start?
__________________
hammer aint. stinkpot aint. sawdust aint. rainbow aint. maco sure as sh!t aint. randle? ha ha ha. |
|
#8
|
||||
|
||||
|
Mine would rev to about 5200 rpm ( small block V8 GM/ Volvo) and it had run as fast as 52 mph on the fishfinder (before I had a good gps) I have the same fishfinder and it is accurate within 2 mph most of the time on my
new boat. I I would do the following 1. Check the timing and then the spark advance 2. If it's a 4bbl, make sure the secondaries are opening. 3.Beyond that, I'd look at the outdrive gearing and prop. But other people know way more about the drives than I ever will. |
|
#9
|
||||
|
||||
|
Charlie, has it EVER run more rpms and just started turnin' slower or has it always (since you got it) topped out at 3600?...if it's something that just started happenin', Franco's on the mark ;) ...on the other hand, if it's always done this, you may have the wrong prop on 'er ??? ...
__________________
'74 V-20/ BF 150 '95 V-21/ BF 150 '84 V-20/ 200 2.4 Merc '87 V-20/'18 F150 Yamaha |
|
#10
|
|||
|
|||
|
Charlie, WOT for my 5.7L EFI is 4400-4800 according to the owners manual. Start with a different prop
__________________
1984 248 Sportsman w/1999 5.7L EFI Mercruiser 2001 Carolina Skiff J16 w/2005 25hp Yamaha tiller control |
![]() |
|
|