omc control

MIKETTURBO · #1 06-09-2007, 08:46 PM

how can i rev the engine without putting it in gear?omc control with johnson 175.only buttons on control are tilt & lockout.

MIKETTURBO · #2 06-09-2007, 08:46 PM

how can i rev the engine without putting it in gear?omc control with johnson 175.only buttons on control are tilt & lockout.

tsubaki · #3 06-09-2007, 09:00 PM

Normally there is a warm-up lever above the ignition key (or to the left of that) either you lift up (while in neutral only) or have to squeeze and lift up. Other manufacturers have a button to push where the shifter pivots to disengage the forward and reverse to use as a warm-up lever while others you simply advance the throttle forward and the rpm's increase. On those to engage the forward and reverse squeeze the handle and push or pull for forward or reverse.

tsubaki · #4 06-09-2007, 09:00 PM

Normally there is a warm-up lever above the ignition key (or to the left of that) either you lift up (while in neutral only) or have to squeeze and lift up. Other manufacturers have a button to push where the shifter pivots to disengage the forward and reverse to use as a warm-up lever while others you simply advance the throttle forward and the rpm's increase. On those to engage the forward and reverse squeeze the handle and push or pull for forward or reverse.

THEFERMANATOR · #5 06-09-2007, 10:10 PM

Many OMC controls go into fast idle by pulling the handle outward and then forward to rev the engine in neutral.

THEFERMANATOR · #6 06-09-2007, 10:10 PM

Many OMC controls go into fast idle by pulling the handle outward and then forward to rev the engine in neutral.

macojoe · #7 06-09-2007, 10:57 PM

[img]http://rds.yahoo.com/_ylt=A9iby4A_TGtG05QA4BCjzbkF/SIG=130liadd5/EXP=1181523391/**http%[/img]

Single lever, dual action control to operate both throttle and shift. Suitable for any type of boat with outboard, inboard or I/O. Can be installed horizontally or vertically, on the port or starboard side of the boat. Pull out handle disengages shift for warm up.

I have this one and it has a seprate handle for warm up

[img]http://rds.yahoo.com/_ylt=A9iby6LGS2tGf9oA7gujzbkF/SIG=12qffotlm/EXP=1181523270/**http%[/img]

macojoe · #8 06-09-2007, 10:57 PM

[img]http://rds.yahoo.com/_ylt=A9iby4A_TGtG05QA4BCjzbkF/SIG=130liadd5/EXP=1181523391/**http%[/img]

Single lever, dual action control to operate both throttle and shift. Suitable for any type of boat with outboard, inboard or I/O. Can be installed horizontally or vertically, on the port or starboard side of the boat. Pull out handle disengages shift for warm up.

I have this one and it has a seprate handle for warm up

[img]http://rds.yahoo.com/_ylt=A9iby6LGS2tGf9oA7gujzbkF/SIG=12qffotlm/EXP=1181523270/**http%[/img]

MIKETTURBO · #9 06-14-2007, 10:54 AM

i tried to pull the handle out,no good,i guess it only has the advance lever for warm up.

MIKETTURBO · #10 06-14-2007, 10:54 AM

i tried to pull the handle out,no good,i guess it only has the advance lever for warm up.