|
|
#1
|
|||
|
|||
OMC seadrive electrical
I’m looking to replace this junction box on my 87 seadrive. Before I write the motor off, I want to do some tests. IMO not safe to power the starter with burned up wire connections. The tilt trim worked fine and motor cranked before I found this. Anyone have one laying around or have any ideas on building a new one, original parts not available for the box...
|
|
#2
05-21-2019, 11:17 AM
|
||||
|
||||
|
Pretty sure that box is the trim & tilt relay box. You can use a harness off of a johnson/evinrude on it with just a little bit of modifying.
__________________
2011 SUNDANCE B20CCR SKIFF, 2011 YAMAHA 90HP 4 STROKE, 2011 KARAVAN SINGLE AXLE ALUMINUM TRAILER, LOWRANCE ELITE-7 HDI, MINN KOTA RIPTIDE TROLLING MOTOR 2000CC HYDRA-SPORT 225+HP EVINRUDE SOLD  AND THE PINK JEEP!!!! R.I.P. http://www.wellcraftv20.com/communit...ad.php?t=11664 
|
|
#4
06-01-2019, 09:51 AM
|
|||
|
|||
|
Fixed my problem, found an old OMC mechanic that was local, he came by and diagnosed as a bad wiring harness, wires corroded. He had an extra in good shape he gave me for 20$. Had to run in through the transom bung, which was a PITA, but now she starts and idles great. No time to put her back together and a sea trial.
|
 |
|
|
Linear Mode
