|
|
#1
|
|||
|
|||
What size shaft for a v20 bracket
Hey guys. What size motor shaft am I looking for in a v20 full transom with a Gil bracket? Found a sweet deal on a 20" but I'm not sure if it's tall enough. Btw it comes with a high jacker plate.
|
|
#2
05-04-2017, 10:30 PM
|
||||
|
||||
|
You're going to have to measure it to see. There is no standard transom height. Most people run a 25 or 30" shaft with a bracket so the engine doesn't get dunked coming off plane, but I've seen some done with a 20" shaft too.
__________________
2011 SUNDANCE B20CCR SKIFF, 2011 YAMAHA 90HP 4 STROKE, 2011 KARAVAN SINGLE AXLE ALUMINUM TRAILER, LOWRANCE ELITE-7 HDI, MINN KOTA RIPTIDE TROLLING MOTOR 2000CC HYDRA-SPORT 225+HP EVINRUDE SOLD  AND THE PINK JEEP!!!! R.I.P. http://www.wellcraftv20.com/communit...ad.php?t=11664 
|
|
#3
05-05-2017, 05:43 AM
|
||||
|
||||
|
most conversions( not V 20's) Ive worked on use a 25 inch shaft engine, but seem to have an issue getting the engine high enough once installed. Personally, Id use a 20 inch motor, mount it so its 5 inches higher than it would be if it were transom mounted, and raise it up from there depending on how it performs.
|
 |
|
|
Linear Mode
