|
|
#1
|
|||
|
|||
zink in foot
the bolt that holds it is stuck. feels like it will snap off. question is does the bolt go all the way thru zink and back in to foot at the top or does bolt just go into the zink?. so if the bolt snaped off would be able to just remove zink and replace zink and new bolt?
|
|
#2
08-04-2015, 07:47 AM
|
||||
|
||||
|
On my Yamaha there's a little rubber cap on top you pop out and the bolt goes down into the trim tab. So if you were to snap the bolt the worst case scenario would be to get a new trim tab/bolt.
**THIS IS NOT ME - STOCK PHOTO FOUND ON THE INTERNETS** 
__________________
 1994 Wellcraft V21
|
|
#3
08-05-2015, 11:28 AM
|
||||
|
||||
|
Need to know what engine as they are all different. Also which zinc as most engines have more than 1 on the lower.
__________________
2011 SUNDANCE B20CCR SKIFF, 2011 YAMAHA 90HP 4 STROKE, 2011 KARAVAN SINGLE AXLE ALUMINUM TRAILER, LOWRANCE ELITE-7 HDI, MINN KOTA RIPTIDE TROLLING MOTOR 2000CC HYDRA-SPORT 225+HP EVINRUDE SOLD  AND THE PINK JEEP!!!! R.I.P. http://www.wellcraftv20.com/communit...ad.php?t=11664 
|
|
#4
08-05-2015, 03:02 PM
|
|||
|
|||
|
it is a 1994 Johnson 175 ocean runner model#j175exera. it is at the rear of foot(nearest the prop)very small less than the size of your thumb
|
 |
|
|
Linear Mode
