|
|
#1
|
|||
|
|||
Trim still going down
I had a leak coming from my end cap, took it the the Mach and he gave me a new cap and seals I told him that it doesn't stay up it comes down very slow and thought that the fixed leak would fix it it didn't ,I see know leaks and was wondering what would cause the trim not to stay up, it's a 1988 mercury out board 150 hp. Thanks
__________________
love to fish 
|
|
#2
09-28-2014, 10:29 PM
|
||||
|
||||
|
It's probably the o-rings for where the trim piston plunger connects to the ram.
__________________
2011 SUNDANCE B20CCR SKIFF, 2011 YAMAHA 90HP 4 STROKE, 2011 KARAVAN SINGLE AXLE ALUMINUM TRAILER, LOWRANCE ELITE-7 HDI, MINN KOTA RIPTIDE TROLLING MOTOR 2000CC HYDRA-SPORT 225+HP EVINRUDE SOLD  AND THE PINK JEEP!!!! R.I.P. http://www.wellcraftv20.com/communit...ad.php?t=11664 
|
|
#3
09-29-2014, 07:32 PM
|
|||
|
|||
|
Is the ram the middle piece.
__________________
love to fish
|
|
#4
09-29-2014, 07:55 PM
|
||||
|
||||
|
open up the manual release and let the engine drop down a bit, then re tighten the manual release. Run it up and down a couple times and see if it still loeaks down, If there's something in a check valve that might be causing the problem, this may break it loose
|
 |
|
|
Linear Mode
