98 200 Johnson cylinder head question

Striper80 · #1 07-05-2014, 04:09 PM

I have a 98 Johnson Ocean runner on my boat that I purchased at the end of last season. I did a compression test and it was 100 across the board. I ran the boat twice last year and it ran well. I just finished going through the boat and fixing a lot of little issues with it so I haven't run it yet this year. While changing the plugs I noticed a bit of corrosion where the head meets the block on each cylinder bank. The lower plugs also were rusted. I'm wondering if this is normal or if I have head gaskets that are failing? I plan on keeping an eye on it. My last Johnson had a new power head on it so there was no corrosion. Thanks

THEFERMANATOR · #2 07-05-2014, 07:46 PM

It's actually semi normal, and is normally when I do head gaskets.

Striper80 · #3 07-05-2014, 09:01 PM

Quote:

Originally Posted by THEFERMANATOR

It's actually semi normal, and is normally when I do head gaskets.

Thanks for good news I guess. When doing head gaskets on these engines do the heads have to be milled? Do the seals around the water jackets fail before the cylinders? I got this boat for about a third of the price of what I saw them advertised for. It ran great and the compression was even so I figured the engine was good. I definitely don't want to damage this engine.

THEFERMANATOR · #4 07-05-2014, 09:19 PM

I don't normally mill the heads unless theres a ned for it. Chances are it will run for a long time ike it is as it isn't uncommon to see corrosion at the seem. When you see rust in the head gasket is when you need to be really concerned. Being a 98 though that is a closed deck block IIRC, and they are more prone to corrosion in the gasket area.

Striper80 · #5 07-05-2014, 09:32 PM

I definitely want to keep my eye on it. My biggest concern is snapping head bolts. That's never fun. Thanks

THEFERMANATOR · #6 07-05-2014, 09:51 PM

The stainless head bolts aren't to bad about snapping, but they do get corroded in due to the dissimliar metal problems between stainless and aluminum. If the gaskets themselves aren't rusty, then I would run it for awhile before messing with it.

Striper80 · #7 07-05-2014, 09:55 PM

Sounds good. Thanks.

Striper80 · #8 07-17-2014, 06:57 PM

Was looking at the heads again today and I think I want to replace the gaskets. I was wondering if you prefer factory gaskets or if you use an aftermarket source.

THEFERMANATOR · #9 07-17-2014, 08:39 PM

About the same anymore. Alot of the OEM parts are now being made by teh aftermarket. These old carbed engines have been out of production for so long, that it was well before BRP's time. So they outsource them to the aftermarket, repackage them, mark them up 100%, and resell them as OEM.

Skools Out · #10 07-18-2014, 10:56 AM

i know the head gaskets say no sealent on them but i've always had better luck with them if i spray copper coat on both sides of the gasket and let it dry over before installing them.