|
|
#1
|
|||
|
|||
Need 6 feet of orig rub rail
I need to replace 6 feet of alum rub rail on my 1982 V20 cuddy that was ripped off in a hard Fall Northwester.
I believe it is original. I posted some pics. I would prefer not to replace the rub rail on the entire boat. Does anyone have some leftover from a project that I can purchase or know a place where I can purchase? I already tried Flounder Pounder Marine without success.    thx Bill
__________________
billfish16 V20 Cuddy 1982 2002 Mercury 200hp 
|
|
#2
05-13-2007, 07:11 PM
|
|||
|
|||
|
Re: Need 6 feet of orig rub rail
Go on line with boaters world or West Marine, I just seen some I thought when I was looking at rubber rub rails. I think they sell them in 6ft sections. Or get up with JeffX, he decided to scrap his project V and his might fit.
__________________
|
|
#3
05-13-2007, 09:59 PM
|
|||
|
|||
|
Re: Need 6 feet of orig rub rail
Thx for the quick response, I shot an Email off to him. I looked at BW and WM and they did not have a match to my rub rail.
thx Bill
__________________
billfish16 V20 Cuddy 1982 2002 Mercury 200hp
|
|
#4
05-13-2007, 11:14 PM
|
|||
|
|||
|
Re: Need 6 feet of orig rub rail
I do have the railing left over, but it looks nothing like your pics. Sorry :-[ If you think you can somehow make it work your welcome to it, though.
|
|
#5
05-13-2007, 11:34 PM
|
|||
|
|||
|
Re: Need 6 feet of orig rub rail
thx for the offer but if I do not find the exact same rub rail I will dress it up with new all the way around.
thx again, Bill
__________________
billfish16 V20 Cuddy 1982 2002 Mercury 200hp
|
 |
|
|
Linear Mode
