Evinrude 1987 140 v4 Rebuild

[THEFERMANATOR]

Don't worry about getting paint down inside of the exhaust ports as it won't hurt it. I would clean up the driveshaft though as paint build up there can cause problems later on as well as clean off the surface where the powerhead bolts down as I've seen em leak there as well.

[nymack66]

Will do Ferm thanks

[nymack66]

Anyone knows the reason for the foam under the cowling? Is it just insulation or is there more to it?
I personally remove it completely because it was all falling apart, my thought process is this loose foam will clog my carbs since there is no air filter!
I was thinking to re-lined it using AC heat shield stuff found at Lowes? or should I run her naked like my current motor?
Pictures of the foam removed, I will sand her down and paint it this weekend..

[Blue_Runner]

Doing a good job there mack. I think the cowling insulation is just noise reduction but I may be wrong. I'm sure there's no less than 100 different materials you could use to accomplish replacing it.....then there's always the option not replacing it too!

I would love to tear one down and build from the ground up like that. You'll be the resident expert when done. We're going to start asssociating you with hall of famers like Skools, Ferm and Spare.

[RidgeRunner]

Just for noise control, some have it, some don't. The insulation is gone on my 90 Johnson and the Merc too. You are right to be concerned about sucking the foam thru the carbs. Happened to a bassin friend of mine. Some of the foam pieces got hung in the reeds on his 225 EFI.
You are actually gonna paint the inside of the cowl? I thought I was anal... Keep up the good work.

[nymack66]

Originally Posted by Blue_Runner

Doing a good job there mack. I think the cowling insulation is just noise reduction but I may be wrong. I'm sure there's no less than 100 different materials you could use to accomplish replacing it.....then there's always the option not replacing it too!

I would love to tear one down and build from the ground up like that. You'll be the resident expert when done. We're going to start asssociating you with hall of famers like Skools, Ferm and Spare.

Skools, Ferm and Spare are my mentors, without the there knowledge and input I would have dump my V a long time ago..During my trials and tribulations with my Frankenstein motor and hull...

[nymack66]

Originally Posted by RidgeRunner

Just for noise control, some have it, some don't. The insulation is gone on my 90 Johnson and the Merc too. You are right to be concerned about sucking the foam thru the carbs. Happened to a bassin friend of mine. Some of the foam pieces got hung in the reeds on his 225 EFI.
You are actually gonna paint the inside of the cowl? I thought I was anal... Keep up the good work.

I know the picture does not show it, but the fiberglass is loose on the inside kind dusty, painting it will laminate it and minimize the dusting of the engine during operation.
This was an experience I found out on my current running engine, I remove the cowling and observe loose dust all over my engine, this was when I found the loose foam, I removed it and paint it...Looks excellent the last time I checked ...

[nymack66]

Some updates, I took the V out yesterday awesome weather here in Fl ..Love it ..
I worked on the Cowling sanding and cleaning, Just before I shoot it I will wash it down with Acetone.

[nymack66]

Cowling inside all cleaned up before painting ...Acetone not yet used ...I will be using a brush on the Cowling inside, I hate the blow back from the spray gun ...

[nymack66]

Moving along ...Shot the inside lower pans today came out excellent..Never shoot white paint in direct sunlight, I mange to create a few runs on the outside which I have to sand and re-shoot not a big deal but ....