Ok Fix it time!!

[macojoe]

65 gals total with two 20 gal side tanks and one 25 gal in the engine well.

[Mac_Attack]

You do good work! Bill Mc ;D

[chumbucket]

Show them all the work I did........................... ::)

[macojoe]

Ha Ha Ha :o What work!! You to busy for you friends now!!
I had to do all by my self!!!!!!! Even my kids were not around!! Except my daughter the first day to help sand the deck!!
But if you hurry you can get in on the paint!! I am all done with the fixing!! and the floor is all filled and sanded.
I have to ru to the hardware store right now to get a brush for the edges. Then I will clean with Xcline and I will be painting in a hour!~! You have just anough time to get here ;D

I will have more pic later today!! I am off to the store! :-*

[macojoe]

First coat paint done!! 1 hour to go till the next coat!!

[chesapeake724]

Very nice. It looks waaayyyy better than what you had. Nice job.

[macojoe]

Ok here is the almost finished deal!!

All thats left is to tune the doors on the rear. I put the hinges a bit tight toghter and they are binding. Easy Fix

I have to make the anchor Pilpit maybe CB will make here this time???

But the paint is done, starboard is done, floor patches all done.

reinstall the engin cover ready to fish!!

[macojoe]

Ok here is the engin cover.

Note I made a new set of rod holders!! I replaced the teak pieces on the back with 3/4 starboard, I bought all new holders $2 each Walfart, and a donated knife holder from CB in the middle!!

Also I added a full cutting board on the top, made of 3/8 starboard.

And I was to cheap to buy a new handle so I made one out of 3/4 starboard. don't look so good but it works!!

[shicks007]

Looks good MJ, I think your addicted ;)

[reelapeelin]

That's a LOT of work, MJ...good stuff...engine cover handle looks good and rod-holders w/the cuttin' board...looks like you're bout ready to go!...

;D