OMC HELP SKOOLS - Page 3

macojoe · #21 08-31-2006, 03:31 PM

Ok went out and started motor and with the key off and motor running the left side when you pull the plug wire off starts to run like crap, the right side runs with no difference.

So this means the left power pack is not shutting down Right??

So its the ground, or B/Y wire (I can't find a Y/B wire going in this one )or the power pack itys self??

Airslot · #22 08-31-2006, 03:39 PM

MJ, the power pack grounds to the block either by it's mount or may have it's own wire. I'd pull that power pack, clean up, and re-mount. Almost bet that fixes ya up.

Airslot

macojoe · #23 08-31-2006, 04:23 PM

Well I am thinking that the Y/B is whats messed up??

Who ever put the packs in (Factory?) put a wire tie so tight that all the wires right close to the pack are bent and look like they might all be broken.

But I know this is not the case. But the Y/B looks really messed up!!

But I no have a tester to test it, going to have to see if I can find one some were?

reelapeelin · #24 08-31-2006, 04:31 PM

Good call Air... ;) ...

Airslot · #25 08-31-2006, 04:49 PM

MJ, are the wires effed close enough to the pack to be on the pack side of the plug/connector? If so you can find a used / inexpensive pack I'd just swap it out.

Airslot

macojoe · #26 08-31-2006, 09:42 PM

well fixed the geround up real nice and thats not the problem.

I am going to try to get a tester tomorrow to see if the wire is good from the key to the motor and then on the motor its self.

I saw a pack on ebay the same number as this one for $20
But he wants to make sure thats the problem first.

macojoe · #27 09-01-2006, 08:47 PM

Ok all fixed!!!

It was the left side, there is a rubber conector that has a wire going into a pin, when they are connected they make contact.

The wire pulled out the small pin in the rubber, looked like all was ok but it was not!

Any way all fixed!! Also fixed his tilt & trim switch, it was broke and all he had was up.
Just got him a on off on switch and just mounted it on the dash all fixed!

That was a tip from CB!! Thanks Bud!!

So tomorrow we wrap things all up and he going to take me out fishing next week so I can wopp some *** in the fishing tour!!

Thanks all for your help!!

Blue_Runner · #28 09-05-2006, 01:27 PM

Cool, nice work #135 ;)

macojoe · #29 09-05-2006, 08:32 PM

Ran it today for a test, went well!

But it had a surgeing problem at first?? at first start and going no wake it was zoom zoom zoom zoom pretty weird??

But after that we oopened it up, went nice, and after a while no more surge?

But on the way back thur the no wake zone I hear it a little bit not bad at all??

Any ideas anyone??

Airslot · #30 09-05-2006, 08:43 PM

Sounds fuel related, low speed side maybe. As you ran some fresh fuel through it it got better right? Best carb cleaner there is, fresh gas.

Airslot