|
|
#11
|
||||
|
||||
Re: How hard to replace throttle/shift sidemount
I had to replace mine.
Usually there are 3 or 4 screws that hold the shift/throttle to a mounting plate. Take those screws out and pull the shifter forward a little, disconnect the cables and wires and swap it over, It's a little tight but not too bad.
__________________
I have been through some terrible things in my life, some of which actually happened. 
|
|
#12
09-30-2006, 11:29 PM
|
|||
|
|||
|
Re: How hard to replace throttle/shift sidemount
Thanks Franco,
I think I can get my hands on a new control for $50 - so am gonna go for it.
__________________
'86 Cuddy (FICHT 150 on brkt) ------ 1988 V20 project in the garage
|
|
#13
10-02-2006, 07:22 PM
|
|||
|
|||
|
Re: How hard to replace throttle/shift sidemount
HEY BRIAN: BEFORE CUTTING ANYTHING CHECK INSIDE THE CABIN, THERE SHOULD BE A PIECE OF SOMETHING TO THE SIDE, COVERING THE TUNNEL IN THE SIDE OF THE BOAT, REMOVE IT AND CHECK IF YOU CAN REACH THE BACK OF THE CONTROL THAT WAY.
LESTERUS
|
|
#14
10-03-2006, 12:07 PM
|
||||
|
||||
|
Re: How hard to replace throttle/shift sidemount
Mine had a piece of plywood like Lesterus said. Between that and the 8" access hole you should have room to do it no problem.
__________________
 1994 Wellcraft V21
|
 |
|
|
Linear Mode
