|
|
#11
|
|||
|
|||
okay figured out wireing last night corosion was the culprit. but desperate for and answer of weither water shouls come out between lower unit and the center case. I hope thats no big deal ready for the water
|
|
#12
07-27-2009, 08:46 AM
|
|||
|
|||
|
Normally no - is it peeing water with good pressure? Are you sure you got the water tube mated to the pump output? if so, you probally messed up the exhaust gasket on the lower unit and its leaking.
If it were me I'd drop the lower unit and verify - better safe than sorry. Kamikaze
__________________
 74 V20 CC with a 150 Johnson (Gone but not forgotten) 89 V20 Cutty with a Tower (Build in process)
|
|
#13
07-27-2009, 05:38 PM
|
|||
|
|||
|
went to the marina and he said it is fine it is peeing so water is going though blocks got wireing replaced today bypassed a safty switch by the tilt motor it was the problem needs replaced but all the end of the wires were bad so I replaced them too. how inportant is it to have that safty switch hooked up what does it do?
|
|
#14
08-05-2009, 09:14 PM
|
|||
|
|||
 still heating up at 30 but figured out the problem. it has a custome build sea drive allum box on the back which is square. well if your going fast say 30 or more since the box was not tapers like the ones you can buy it directs the water away from the motor so it cannot take in much water mostly air. bad news I have to take the motor off and have the box rewelded. good news thats a cheep fix probably 40 to get re welded after I cut it up to add a taperd bottom to it. the good news is my gf loves the old boat as well it is nice to ride in just wish i lived near the ocean to really get some use out of it .
|
 |
| Tags |
| 1976, 235, evinrude, v20, wellcraft |
|
|
Linear Mode
