Pulpit install / assembly... - Page 12

msbhammer · #**111** 05-08-2007, 06:04 PM

Nothing here to report AIR on my chain locker cap. Not until some O.T. comes in. But I did play with the plasma cutter again last night. ;D ;D ;D ;D

Airslot · #**112** 05-08-2007, 10:39 PM

Well, I underestimate myself. I just got the bolts sealed and tight. Pulpit is done w/ 2 10" cleats, self launching roller, and anchor locking pin. I even have the anchor mounted. I still need to solve my chain pipe problem, but that no big deal... :)

msbhammer · #**113** 05-08-2007, 11:38 PM

Good job AIR, I did a quicky today before I went to work as well.

Airslot · #**114** 05-08-2007, 11:48 PM

I was just thinking, there are 19 bolts, a whole tube of 5200, and half a tube of 4200 involved in this project. I should be able to lift the boat by thr pulpit ;D

msbhammer · #**115** 05-08-2007, 11:50 PM

OOPS, I used 5200. ;D

Airslot · #**116** 05-08-2007, 11:51 PM

And if I recall, you have 2 more bolts than I do ;)

reelapeelin · #**117** 05-09-2007, 09:24 AM

Quote:

Originally Posted by Airslot

I should be able to lift the boat by the pulpit ;D

I get a wild mental picture of a V-20 danglin' from a crane
8)...but I get a lot of wild mental pictures ::) ...

Airslot · #**118** 05-09-2007, 09:34 AM

Speakin of pictures...camera phones ain't so hot in the dark, but this is what I got:

C YENSEN · #**119** 05-09-2007, 09:56 AM

so how you gonna fix the hole in the deck Air?

Airslot · #**120** 05-09-2007, 10:10 AM

Well....good question. I may cover it with starboard and put the deck pipe through that too...

I may cut a new hole just off from the old one and use the plug w/ some Formula 27 to repair the area,,,

I may wake up Sunday morning and figure it out then ;)

One of the problems is that I haven't committed to a new larger size deck pipe, re-use mine, or replace with one just like it. Oh...the problems we face ;D