|
|
#13
03-17-2007, 05:41 PM
|
||||
|
||||
Re: Drill Bit / screw sizes
I take the screw and hold a bit up to it...if I can see "a little bit of the edge of the threads" stickin' out wider than the bit-shank, that's the one ... and use a cone-shaped bit or counter-sink edge of hole like MJ says above...fiberglass does not take screws like wood does... ;) ...
__________________
'74 V-20/ BF 150 '95 V-21/ BF 150 '84 V-20/ 200 2.4 Merc '87 V-20/'18 F150 Yamaha 
|
|
|
Threaded Mode
