White Navigation stern light - Page 3

skpablo · #21 11-30-2006, 11:50 PM

Thanks Franco. I have 2 soldering irons as well. It's a plan.

I am also thinking that we're pretty close in years on the planet. 1955.

skpablo · #22 11-30-2006, 11:50 PM

Thanks Franco. I have 2 soldering irons as well. It's a plan.

I am also thinking that we're pretty close in years on the planet. 1955.

Franco · #23 12-01-2006, 12:14 AM

1956 model here LOL

Franco · #24 12-01-2006, 12:14 AM

1956 model here LOL

msbhammer · #25 12-01-2006, 12:42 AM

Hey Tin, I dont know the name of the connectors I used when I did my bildge pump. Each wire slid into a flexable platic connector with metal inside. I then crimped them and added that wet tape in a can, and then wrapped them in electrical tape.

msbhammer · #26 12-01-2006, 12:42 AM

Hey Tin, I dont know the name of the connectors I used when I did my bildge pump. Each wire slid into a flexable platic connector with metal inside. I then crimped them and added that wet tape in a can, and then wrapped them in electrical tape.

TheTinMan · #27 12-01-2006, 01:26 AM

OK Hammer, not bad, would've been a bit better if used heatshrink instead of the tape but you should be OK for awhile, good job ;)

TheTinMan · #28 12-01-2006, 01:26 AM

OK Hammer, not bad, would've been a bit better if used heatshrink instead of the tape but you should be OK for awhile, good job ;)

Franco · #29 12-01-2006, 02:21 AM

They do make crimp connectors with epoxy coated heatshring tubing, I kept a few on board for emergency repairs, they do a pretty good job, but soldering is best

Franco · #30 12-01-2006, 02:21 AM

They do make crimp connectors with epoxy coated heatshring tubing, I kept a few on board for emergency repairs, they do a pretty good job, but soldering is best