well here she is!

[Kajun]

update: well got the hoist modified yesterday...worked great...got the engine mounted on stand FINALLY!.....hooked controls up...did a spark check.. got spark on all 4 cyl's!..compression good..spark good..all that i need to do now is fuel system...but i'm kinda lost with this VRO stuff...i dont want to use it but i need to figure out how to disable it totally so i dont screw it up in case i decide to use it later, manual tells me nothing on how to disable it....also got a few wires that i dont know what they go to still....i'd like to hook some gas and water up to it and try starting it today .

also..if this motor was using the VRO prior...are the carbs ready to accept a mixed fuel or is it set to a lean gas setting now and i would have to adjust it for a mix?

here's some pics...









is this where the battery cable ground goes?






have no idea where this wire goes.. its a pinkish/tanish colored wire





this fitting on the front of the fuel pump doesnt have anything hooked to it...what goes there?




on the trim harness there are 2 wires not connected to anything.. the plug is a 3 wire plug...are these just extras?





here's my friend dave's canvas awning shop......all the enclosures you can make lol

dave modifying the hoist legs






sewing shop side..all the sunbrella you can want lol