patching up transom

[macojoe]

well I have gone from OMC, Merc, Yamaha and they have all had the same bolt holes.

I used 5200 on mine but 4200 should be ok?? I like that the 5200 takes longer to cure and I think that gives a better bond??

Just go around the whole bracket make a line , complete circle around the bolt hole, then a line to the next hole and do the same. This is not a place to skimp on the 5200, load it up!!!!!!

After bolts are tight wait 30 min and retighten to be sure!!

DO NOT CUT OR CLEAN EXTRA 5200 TILL DRY!!

put 5200 on all bolts when you insert them.

YOU CAN"T USE TO MUCH 5200!!

Did I say you should buy stock in 3M yet??