|
|
#2
12-21-2005, 03:19 PM
|
||||
|
||||
Re: Motor Shroud?
I had made a replacement sea wall/shroud/bait table for my Robalo 1820 I just sold out of Star Board. It was meant to keep some of the water I used to get from coming onto the floor while drifting and it did it well. But I noticed a big benefit from it was how much it cut down on the noise from the 150 Merc. On that boat the motor was 4-5 feet behind you at most. I put four scuppers in the bottom and attached it permanently where the factory sea wall ( short, not water tight) was at and made a removable taller section with a bait table on it I would take off when trailering so I could tilt the engine all the way up
__________________
Willy 1986 V20 Old School 1992 V20 1992 150 Yamaha 1997 HydraSport 2250 Vector 2009 17' G3 Outfitter "G Spot" http://www.youtube.com/watch?v=TDebw...eature=related "I won't be wronged, I won't be insulted and I won't be laid on a hand on. I don't do these things to others and I require the same from them" JW 
|
|
|
Threaded Mode