|
|
#11
|
|||
|
|||
Carb girl? My bad. Erase the girl.
The carb issue maybe that's what I wanted to write But is there a carb girl out there? I'm good with that
__________________
love to fish 
|
|
#12
06-26-2023, 06:41 AM
|
||||
|
||||
I found her
 
|
|
#14
06-26-2023, 07:37 PM
|
|||
|
|||
|
Yep, sounds like a float stuck or maybe trash in between the needle and seat not letting it close when the bowl is full. You can get a carb kit and go through it. Its not hard, really. Check the float, maybe saturated with gas making it too heavy, holding the needle open.
__________________
 77 V20 cuddy with 170 I/O Mercruiser 72 16ft. Carolina w/a 25hp Evinrude
|
|
#15
06-28-2023, 07:01 PM
|
|||
|
|||
|
Phat daddy send her to me. This would be a piece of cake for her and as far as the float being stuck, I took the bowl off and it was stuck because a metal piece came off and wedge itself between the float and the wall. The piece that came off is call a baffle, I don't know what it does but was told it keeps the fuel in the bowl flowing when you make hard turns. I put the bowl back on to test it but fuel was leaking from the bowl gasket. I just ordered a kit that has the bowl gasket and am waiting to put it together. I'm keeping my fingers crossed . I never messed with a carb before and am hoping it lines up ,the gasket with the bottom of the carb. I will let you guys and girls know how I make out.
The problem is that I'm doing this while it's still on the block,not to much space to work with, I just have to make sure I don't drop the screw. That would reely suck
__________________
love to fish
|
 |
|
|
Linear Mode
