Hey Spare - choke repair?

[spareparts]

loosen the three screw that hold the choke coil in place(round black plastic thing). Pull teh flame arrestor off so you can see the choke flap. Advance the throttle just a little so theres no binding on teh carb linkage. With teh engine dead cold, turn the choke coil till its the least amount of tension to close the choke. You're in a cooler area, so you want a little tension, down here, i back them all off. When you go to start the engine cold, advance the throttle twice, then pull it back to a high high idle position, if it doesn't start, pump the throttle twice again and try to start. Don't pump the throttle while you're spinning teh motor over, it will flood it