V20 Cuddy I/O Motor Box

[bobj]

pretty sure the marks on top are where a handle was installed for lifting the cover. Probably by a PO. If you want a handle a flush mount handle works well there w a little work. The channel should have a matching piece that is installed in reverse of that piece ( one up one down). It will engage that piece and support the back of the cover. Latches can be installed on the floor close to the transom if needed. engine dog house latches can be stainless or rubber covered and can be found on the net. good luck

[3 Squids]

Sounds just like my 85. There’s an aluminum lip to “support” the box when closed and 2 blocks of wood on the floor to keep it from sliding but that’s it. No seals, locks...nothing. Seems to work fine just doesn’t keep the water out much but hey, it’s a boat.

[cmk245]

Marks on rear Top of motor box WAS from a Handle Previous owner must have installed. Had "Stainless Straight Blade screws " Self tapping that were cut off flush. Never saw a handle installed like that, just the flush ones, like a another guy mentioned.

But a handle is needed there to aid in lifting box.
Like the ideas of latches on sides.

Still has the same type handle on the lower front, that I see in a lot of photos.
That one was thru bolted. Looks original, with Phillip's head screws.

BOTH were Crappy Zamak !!
Both are being replaced.!!

Teak blocks on sides and front of motor box, still there , and still good, after 40 years...

Thanks for all the replies!!
All my photos come out sideways, all where uploaded in right position ??

[3 Squids]

This is the only handle on mine. Located on the top at the rear. Only handle I’ve needed. Mine has a spray type foam in the box for sound.

9C684062-DAE3-42B6-9A8A-36E32ED91888.jpg

[cmk245]

Good idea Flush handle. was that there from Wellcraft, or installed by you ?

Mine has one on the front lower, also which looks like factory, as I have seen alot of earlier V20"s with one there.

So is spray foam, mine is just raw resin covered wood and glass.

Did Wellcraft ever put something on the inside?

[3 Squids]

I don’t know if my latch and insulation is original or not. I know it’s well built. I’m 280lbs and stand on it all the time to sight cast and have never had a problem.

[Dschaffer]

Originally Posted by 3 Squids

This is the only handle on mine. Located on the top at the rear. Only handle I’ve needed. Mine has a spray type foam in the box for sound.

Attachment 7976

Mine is an 88 and has the same set up as this picture. I don’t have any latches and that’s never been an issue. Hopefully I remember to take a couple of pictures to share sometime tomorrow. For whatever reason, I don’t ever get notified about posts on this forum (I do subscribe for email alerts).

[cmk245]

Don't feel bad, I don't get email notifications either, and checked the box for them.
If I don't check the Forum, would never know i got a reply....

Thanks for your reply.