Quote:
Originally Posted by Myfathersson
Twist - I was wondering, in shaping your stringers are you matching the bare fiberglass height of the original? Reason I ask is there was 1" of peanut butter bridging the gap between my stringer tops and the sole. I've read many folks on iBoats and THT use PL Premium to secure the sole but I don't think I'm going to make up 1" of gap with a polyurethane adhesive. My thought is to increase my stringers by about 3/4" so there isn't as much gap to cover.
|
I’m doing a mix of what you talked about. I went through took all the measurements and then transferred that to the sides of the hull. Used a y foot level to confirm the heights. This created a floor height level. I then ran strings at the sights of the bulk heads and stringers to get the heights. Thankfully the heights were all very close 1/4 inch off. Used a common middle height, that put me close.
Skunk, I was thinking the same thing.
08-07-2019, 06:48 AM
Threaded Mode