Rebuild Repower

[Slightly_Twisted]

Originally Posted by SkunkBoat

nice work

Interesting the different models of V20s. Yours had a full transom and it was flat all the way across. My 84 cuddy had a motor well and the transom angled from the sides. it was actually 3 pieces of plywood.

I was concerned when I first saw your post that you didn't consider that but I can see in the pix its OK. If I used a flat transom on mine the cap and motor well would not have fit when they went back on.

Thanks Skunk,

Oh mine is curved by a lot. It was original with a seadrive and has a small flat spot in the center. The only way I could match the curve was using the plywood on the outside and drew the inside plywood one at a time. When I bolted them in I used metal flat bars vertically.

The photo attached is looking down in the middle of the transom.