New here with a v20

[oteps]

welcome. You will like this site. Everyone is helpful.
I have a dual console and made a top for mine. It was an experiment for when I get a bigger welder that does aluminum. Its very light, made out of steel tubing I had laying around from a small pool frame. I just bunjee a tarp to it when out in the water. THe problem is there is no x brace for the legs so it shakes while trailering. I put some braces from the legs to the top but without taking away head room its pretty much impossible unless I attach them to the console. If I built it out of thicker aluminum I think it would be ok. But the hard top would have to be made very light if I would go that route. Im too dumb to figure out how to post pics or I would.