|
|
|
|
#3
06-04-2018, 03:41 PM
|
||||
|
||||
 Got a buddy to make this new helm/dash piece for me out of half inch starboard. I thought the v20 logo turned out great! I left the top right hand side blank in anticipation of adding a trim tab switch there 
|
|
#4
06-04-2018, 05:58 PM
|
||||
|
||||
|
Looks great. What paint did u go with? I will drop mine off after Labor Day so u can do mine also.
Id be concerned about the transom extension. Hard to tell from pics how much of the load u spread on the existing one. Dash looks great also
|
|
#5
06-04-2018, 07:50 PM
|
||||
|
||||
|
Thanks George!
I had the same concerns about the transom, but a buddy of mine that knows allot more than I do, helped me do it, after he convinced me it would work. The motor is mounted pretty evenly between the old transom and the new...  
|
|
#6
06-04-2018, 07:53 PM
|
||||
|
||||
|
We used an enamel based paint that we got from Sonny at Miracle Paint Center in PCB. It's not the finish of Awlgrip or any of the name brand stuff, but it cleans up pretty good and has it sealed nicely.
|
 |
|
|
Hybrid Mode
