battery placement

[Slightly_Twisted]

Well the cold up here has really slowed down the work.
I’ve been inside soldering wiring harnesses for the new deck lights.
This week was the first time I’ve been able to get outside.

So I went a little over kill on the wiring. The lights and bilge are soldered, two coats of liquid electrical tape, heat shrink tubing, then electrical tape over top. I pretested every connection to make sure I only ran the wires once.
Today I soldered the new led lights on. Four white deck lights, two on each side. And four blue lights hidden in the rod boxes. I’ll get photos of the blue ones when I put in the rod boxes.

Finished the new control panel, the large wooden space will get a flush mount 7 inch fish finder once I order one.


Stay warm