Need recommendation on new trailer for my '87 V20 Steplift

[sgnhis]

Greetings and Merry Christmas! I have 1987 V20 steplift with the original 150 Yamaha--I love this boat. But it's time to say good bye (or more like good riddance) to my OLD tandem trailer w/ rollers. My question is do you think I can get away with a single axle bunk trailer this go around? I only use the trailer twice a year the and the trip is under 2 miles on rural roads at low speeds. Any guidance would be much appreciated. Thanks!

[jvitiel]

Short ride, no problem at all (assuming a trailer up to the task). Bunks vs rollers depends on the ramp but should be no big deal if it's only an annual haul.

Welcome and Merry Christmas !!

[sgnhis]

That's good to hear jvitiel thanks for the come back!

MERRY CHRISTMAS!!

[SkunkBoat]

You can definitely get away with a 3100 single, no brakes.

[sgnhis]

Thanks SkunkBoat I assume you are talking about a Venture VB-3100? If so they come with brakes standard (which I don't want) do you think I could go with a VB-2800 that has no brakes instead?

[Destroyer]

Check with your state laws concerning brakes. Some states require brakes over a certain length and some require brakes over a certain weight. In all cases, brakes are just a damn good idea. Personally, I'm partial to surge actuated hydraulic drum brakes, but that's just me and I take extra precautions to keep mine working properly. In your situation, with a 2 mile run on rural roads I would think you would be okay, but for anyone that trailers over highways and interstates @ 50-70 mph brakes become a necessity rather than a luxury. Your and other peoples lives could depend on the distance it takes to stop and without brakes at those speeds you effectively double your stopping distance.

Brand is almost unimportant, since all trailer makers must meet certain requirements by the DOT in order to sell their trailers. What is more important is the load rating of the trailer, the physical size and what it's made out of. You basically have 3 choices.... Painted, Galvanized and Aluminum. If you are going anywhere near salt water than you want to avoid painted like the plague. My personal preference is Galvanized, but that's just me and everyone has their own likes and dislikes.

Rollers vs Bunks have been the topics of numerous discussions on this board, with the results being almost evenly divided 50-50. What has become more apparent is the type of ramp you launch from. Most Northern ramps are steeper and shorter than ones found down south and roller trailers seem to be the most preferred. However, down south where the ramps are longer and not as steep the Bunk trailers seem to hold sway as the most preferred style. Again, it's entirely up to you.

Just make sure that when you buy your trailer it is long enough to properly support your boat. (Looking underneath the boat as it's mounted on the trailer, the end of the bunk or the roller should be even with the transom of your boat). Too short a trailer will (over the years) result in the hull developing a dent in the hull due to the extra weight of the engine on the stern of the boat. This is known as cupping and can effect the performance of your boat. So make sure the trailer is the proper length.

[spareparts]

my boat was towed from Atlanta to Charleston on a single axle trailer before I bought it. I prefer a tandem, but a single will work. If you decide to get brakes, get disc if you actually need them, get drums if you are only getting them to be legal. After one season in salt, the drums will be frozen in place, remove the shoes and bolt the hubs back on. The disc will probably;ly be frozen as well if it sets parked a lot, parts for the disc generally cost more

[Striper80]

I prefer a dual axle trailer because I have a 130’ driveway to backup. The dual axle is a lot easier for me. That said I’ve seen plenty of V’s on singles.

[SkunkBoat]

Originally Posted by sgnhis

Thanks SkunkBoat I assume you are talking about a Venture VB-3100? If so they come with brakes standard (which I don't want) do you think I could go with a VB-2800 that has no brakes instead?

2800(pounds) isn't going to cut it. I had a Load Rite RS-193100RT. Rollers,no brakes. Boat fit right. The trailer guy said it met the minimum for the boat weight. Only used for short trip twice a year to launch & recover for season.

As for brakes. depends on state regs. For a short haul twice a year they are more trouble than help. Because they don't get used enough they will be locked up every spring and fall unless you disassemble them ...they suck.... been there...

Brakes that lock up are more dangerous than none on a rig that is light enough to go without them. Your boat is 2000, motor 400-500, gas 300, batteries andgear puts you right at 3100

[mawshj]

many trailers weigh 1000 (+) lbs so you need to be able to stop 4000 lbs