Thoughts on my flexing transom

[jvitiel]

Originally Posted by SkunkBoat

I hate to tell you... but that is shot.
I would not want to ride in that boat

If you can't handle a transom fix like mine, there is a shorter way.

Take off the aluminum trim and cut off the 1.5" strip of glass. Use a chain saw to dig out the crap as far as you can down and sideways. Clean the inside glass as best you can and pour to fill.
It will be way better than what you have now.

Thanks Skunk,

I'm going to get some quotes but if it's too expensive, your shortcut method sounds better than just using plates. If I go that route and basically pour half the transom do you think that will make it difficult or impossible to do a proper job down the road?