|
|
#1
|
|||
|
|||
Carb cleaning
It has been a while guys, but I am finally trying to get the V up and running again. Skool rebuilt the carbs (1988 Evinrude 120 VRO looper, VRO disconnected) several years ago and it never has really been run since. I was able to get it fired and running but one needle valve is apparently sticking and leaking fuel, I opened it up and saw dried junk in the bowl. I have looked back through several threads and now know not to use carb or harsh cleaners due to the carbs being plastic. I saw in a thread referencing using electronic contact cleaner but which one?
__________________
1973 Wellcraft V20 w/1988 Evinrude 120hp 1978 ProLine 20ft w/19?? Evinrude 150hp 
|
|
#2
11-08-2016, 02:21 PM
|
||||
|
||||
As long as they say "Safe for plastics" either of them should be okay. But having said that, I would try a few test sprays on the *outside* of the carb in an area that doesn't have anything attached to it. (Just bare plastic). Give it a spray, let it sit till it's all evaporated, then run your fingernail across the plastic. Does it feel hard and smooth or does it feel a little soft? If hard you should be fine. If soft go NO further.
__________________
1987 V20 w/1987 150HP Yamaha on a Shoreland'r Trailer 1978 16.5 Airslot w/1996 120HP Force on a Four Winns trailer 1996 V21 w/1993 200HP Mercury on a Shoreline Trailer All towed by a 5.7L Hemi Durango. If God didn't have a purpose for us we wouldn't be here, so Live simply, Love generously, Care deeply, Speak kindly. (Leave the rest to God)  Silence, in the face of evil, is itself evil. Not to speak is to speak, not to act is to act. God will not hold us guiltless.
|
 |
|
|
Linear Mode
